Installing Ford Fiesta H1 LED Main Beam Conversion

Start by removing your headlamp.

Two Torx bolts hold it in, one towards the top of the headlight near the wing and the other towards the front of the slam panel.

Once the headlight is out, remove the rubber cap from the rear.

Remove the original bulb by squeezing and pulling the bulb holder outwards.

Remove the bulb and install the H1 Fiesta Main Beam Wiring Harness.

Once the wire is connected you can install the H1 LED Bulb into the Headlamp.

Then secure using the Bulb Holder.

Then connect the wires.

Took in the wiring and then replace the rubber cap.

You can now replace the headlight and your good to go.